Omron NT - SUPPORT TOOL FOR WINDOWS V4 Operation Manual page 146

Common Operation
Setting the current object status as the existing value
Example: Bit memory table entry
Address and Bit set
for [End Range]
CIO area
15
Bit
Bit 15
HR area
Before change
0000010
0000012
0000100
0000110
0000115
S Operation procedure
(1) [Tools] (menu bar)
(2) Select the type of word before the change in the [Channel] box.
(3) Specify the range of the change by setting addresses at the [Start Range]
and [End Range] boxes.
(4) Specify the word and the address after the change in the corresponding
boxes in the [Change To] area.
(5) Set a check mark in the Change Comment check box as desired.
If a check mark is set in this check box, I/O comments appended to the ad-
dresses before the change are also appended to the addresses after the
change.
(6) Click on .
Register the status of the selected object as the existing value of the same kind of
object. This feature allows the status of the object, when it is registered to the
screen, to be changed, eliminating the operation steps to modify the property of
the object.
Note that the PC (PLC) address and reference memory table entry cannot be
registered as the existing value.
(1) Specify the object to be registered as the existing value (select only one ob-
ject).
(2) [Draw] (menu bar)
up edit menu)
Address and Bit set
for [Start Range]
Word 1 CIO area
0 15 10
0 15
Word 11 HR area
[Change Address]
[Use as Default] (Or select [Use as Default] from pop-
Section
Word 0
0
0
Word 10
[Change To] – [Address]
(start address after the change)
After change
H0001000
H0001002
H0001006
H0001100
H0001105
6-1
133