Omron NT - SUPPORT TOOL FOR WINDOWS V4 Operation Manual page 244

Graphs
Value: Specify this item if a –100% value is set by a constant; set the value
to be taken for a –100% value.
Note that specification for –100% is valid only when [Display Sign] is selected.
Guidance:
S Analogue meters are displayed as follows depending on the settings of
[Shape], [Direction] and [Display sign].
Assumptions
Direction: Clockwise, Display: 30%
Display Direction:
Shape
sign Up ( )
ON
Quarter Quarter
OFF
ON
Semi Semi-
Circle
OFF
ON
Circle Circle
OFF
S Which of [0 to 100%] and [-100 to 100%] analogue meters is displayed should
be selected with the setting for [Display Sign] in the general attributes.
Check mark set:
Check mark not set: 0 to 100% display
S A present value is displayed as follows according to the types.
Needle
Direction: Direction:
Down ( )
–100% to 100% display
Fill
Section
Direction:
Left ( ) Right ( )
6-9
231