Omron NT - SUPPORT TOOL FOR WINDOWS V4 Operation Manual page 481

Data Conversion
Correction of image codes
Correction of library codes
472
S Conversion result, error message and corrective action
Status before
Conversion
With an NT30/ With a PT model
NT30C, an ex- other than NT30/
tended I/O input/ NT30C, the setting
output table is set. of an extended I/O
input/output table is
discarded.
When an image code is converted between a conventional and a new model,
conversion is executed in the manner shown below due to differences in the
image codes between them.
S Difference
New models:
Conventional models:
S Conversion result, error message and corrective action
Status before
Conversion
Conventional model New model
Assume the code is The code is X –
X. FE1F.
New model Conventional model
Assume the code is The code is Y +
Y. FE1F (if the con-
verted code is out-
side the usable
range, the code is
fixed as FE20.)
When a library code is converted between a conventional and a new model, con-
version is executed in the manner shown below due to differences in the library
codes between them.
S Difference
New models:
Conventional models:
S Conversion result, error message and corrective action
Status after
Error Message
Conversion
––
0001 to 0FFF (hexadecimal)
FE20 to FEFF (hexadecimal)
Status after
Error Message
Conversion
[E]
Image Table entry
has been con-
verted.
[W]
The code for screen
element [Object
Name] has been
converted from
XXXX to YYY.
[W]
The code for screen
element [Object
Name] has been
converted from
XXXX to YYY.
1000 to 3FFF (hexadecimal)
FA20 to FAFF, FB20 to FBFF, FC20 to FCFF, FD20 to
FDFF (hexadecimal)
Appendix A
Corrective Action
Correct the screen data
and a host program so
that unusable table
entries can be replaced
with inputs/outputs of a
host, etc. (Refer to 7-5
Extended I/O Input
Table and 7-6 Extended
I/O Output Table.)
Corrective Action
If the code after conver-
sion differs from the
image code to be used,
change the code to the
correct one. (Refer to
8-1 Image Editor.)