Omron CP1E CPU UNIT SOFTWARE User Manual page 129

Built-in Input Tab Page
Interrupt input settings
IN2 Select Interrupt for
IN2 to IN7.
IN3
IN4
IN5
IN6
IN7
Note 1 The power supply must be restarted after the PLC Setup is transferred in order to enable the interrupt
input settings.
2 IN6 and IN7 are not supported by E10 CPU Units.
Assigning Interrupt Input Terminals
The following input terminals can be used for interrupt inputs. These terminals correspond to CIO 0.02
to CIO 0.07 in I/O memory.
Input Terminal Block on CPU Unit with 20 I/O Points
Upper Terminal Block
DC Power Supply
+ -
COM
NC
Writing the Ladder Program
Writing the Interrupt Task's Ladder Program
Create ladder programs for interrupt tasks 2 to 7, which are executed for the corresponding interrupt
inputs. Right-click a program in the CX-Programmer and select Properties. Select interrupt tasks 2
to 7 in the Task Type Field of the Program Properties Dialog Box.
CP1E CPU Unit Software User's Manual(W480)
Corresponding
bit address
CIO 0.02
CIO 0.03
CIO 0.04
CIO 0.05
CIO 0.06
CIO 0.07
Interrupt input IN5: CIO 0.05
Interrupt input IN3: CIO 0.03
L1 L2/N COM 01
NC 00
CIO 0
Interrupt input IN2: CIO 0.02
Interrupt input IN4: CIO 0.04
Scheduled
interrupt task
2
3
4
5
6
7
Interrupt input IN7: CIO 0.07
03 05 07 09 11
02 04 06 08 10
Interrupt input IN6: CIO 0.06
10 Interrupts
10
10-5