Table of Contents
Advertisement
Installation
Installing the HotWire 5170 Remote
Termination Unit
About the RTU Rear Panel
2-2
For RTU installation, you need the following:
Cables and cord supplied in your HotWire 5170 RTU package.
A DSL access point already installed and near the location of the RTU.
An Ethernet card already installed in your PC.
An available 110V ac power source.
You may also want a small screwdriver to secure your serial port connectors. If
you ever need to perform the External Ethernet loopback test on your Ethernet
card, you will also need an Ethernet Loop cable. This is not supplied with your
RTU but the pin assignments and wiring to make this cable, along with the pin
assignments for all the other cables, are provided in Appendix B,
Assignments
.
The following figure shows the rear panel for your RTU. The installation uses the
following jacks and port:
DSL
Serial (optional)
LAN
PWR
The V.35 port is not used but is included to accommodate future enhancements
to this product.
PWR
0
1
Use the following procedure to install your RTU.
April 1997
LAN
SERIAL PORT/V.35
Pin
DSL
496-15215
5100-A2-GB22-10
Advertisement
Table of Contents
