IP Addressing
Selecting an IP Addressing Scheme
Your IP addressing scheme depends in part upon whether the Hotwire 797x
Standalone Termination Unit is connected to a DSLAM card running in IP
Conservative mode.
Configurations Not Running IP Conservative Software
For a configuration not running IP Conservative software, the NTU's network
interface IP address is assigned through the peer IP address of the LTU's Network
Interface menu.
A DSLAM-mounted termination unit is assigned an IP address and subnet through
the DSLAM Configuration
address is assigned, you can use the ATI to assign:
T
T
All Configurations
The NTU obtains its IP address when the PPP link is established over the EOC.
Use the ATI to assign:
T
T
The Peer IP Address refers to the EOC interface IP address of the unit configured
as an NTU. When the LTU and NTU negotiate a connection, the NTU receives its
address from the LTU.
7900-A2-GB21-20
DSL Cards
Peer IP address. This address is used as the IP address of the remote unit.
See
Table A-1, Network Interface Options,
Options .
An IP address for each NMS to act as a trap manager. See
Traps Options,
in Appendix A, Configuration Options .
An IP address for each NMS. See
in Appendix A, Configuration Options .
An IP address for the TFTP server you wish to use to upload and download
configurations. See
Configuration Loader
Configuration , and the documentation for your TFTP server.
December 2001
Set IP Address menu. Once the
in Appendix A, Configuration
Table A-14, SNMP
Table A-13, SNMP NMS Security Options,
in Chapter 3, Initial Startup and
5
5-1