Troubleshooting; Common Problems And Solutions; Installation Problems - Matrox Meteor-II Installation And Hardware Reference Manual

38 Appendix A: Troubleshooting

Troubleshooting

If you have problems using your Matrox Meteor-II board, please try the following:
• Check for disconnected power cords.
• Read the Common problems and solutions section in this appendix.
If your problem is not addressed in this chapter or if the solutions suggested don't
work for you, contact your local Matrox representative, Matrox Sales Office, or
the Matrox Imaging Customer Support Group.
For up-to-the minute release and customer support information, visit our website:
http://www.matrox.com/imaging

Common problems and solutions

Installation Problems

➘
PC/104-Plus board cannot be stacked
• If you cannot stack your PC/104-Plus board, check the connectors of the last board
in the stack and determine if any of its PCI connector's holes are filled. If this is
the case, cut the corresponding pins on your board. See the section Installing
Matrox Meteor-II /Multi-Channel for PC/104-Plus in Chapter 2.
• If your computer has PC/104 modules, you must re-stack them so the PC/104
modules are on top of PC/104-Plus boards. Be sure to reset the rotary switches for
your new stack configuration.
➘
Board service fails to start
This could happen due to the following two reasons:
• The MIL Matrox Meteor-II drivers are not installed correctly.