Table of Contents
Advertisement
Nip rolls D
D Solenoid
Paper path
sensor 16
Nip rolls E
VIEW INSIDE TOP LEFT OF IME
Figure 5 Bypass feed operation
Principles of Operation
Tray 5 Module
Overview
The tray 5 module is a high capacity paper source that can be used as the primary paper
feeder for the system. It provides a single tray with a dedicated paper size setting that can be
set to A4 or 8.5 x 11 inch, long edge feed, (LEF). It provides paper at the rate required by the
machine to which it is attached.
Bypass Tray 4
Tray 5
The tray 5 module is positioned to the left of the machine
by a fixed base. Runners on the base allow the unit to be moved to the left for access to the left
hand door, for jam clearance.
Power is derived from the main machine via a combined, communications connector. The tray
can be reloaded with paper while other paper sources are in use.
A transport lock mechanism allows the tray 5 module to be moved safely, when not attached to
the IME.
Configuration
The paper tray size is a mechanical setting that can be adjusted to accept 4000 sheets either
A4 or 8.5 x 11 inch (80 gsm / 20 lb.), long edge feed stock. The paper size is pre-set at the fac-
tory and is dependant on the market region. There is no paper size sensing available in tray 5.
Kits are available to convert tray 5 to accept the following media:
•
A4, short edge feed
•
8.5 x 11 inch, short edge feed
February 2013
8-52
Figure 1 Tray 5
Figure
1. It is attached to the machine
ColorQube® 9303 Family
Advertisement
Chapters
Table of Contents
