Xerox ColorQube 9303 Series Service Manual page 1797

Ejector roll motor
encoder sensor
(Q12-097)
Figure 17 Ejector roll components
ColorQube® 9303 Family
Ejector roll motor
(MOT12-233)
Ejector plate home
sensor (Q12-184)
• Pressing and support motor, MOT12-323 - A DC motor, located below the HVF rear
tamper. This motor moves the support fingers to the 'out', 'init' and 'home' positions. The
pressing fingers are mechanically linked to the support fingers so that as the support fin-
gers leave the home position, the pressing fingers move down to hold the previous set on
the stack. Refer to Figure
• Pressing and support encoder sensor, Q12-093 - This is a standard flag, encoder-disc
sensor, sensing the rotation of the pressing and support motor. Refer to
• Pressing and support A sensor, Q12-172 - A flag sensor, detecting the support fingers in
the 'home' position. Refer to
• Pressing and support B sensor, Q12-171 - A flag sensor, detecting the support fingers in
the 'init' position. Refer to
• Pressing and support C sensor, Q12-173 - A flag sensor, detecting the support fingers in
the 'out' position. Refer to
February 2013
8-103
18.
Figure 18.
Figure 18.
Figure 18.
Principles of Operation
Figure 18.