Cowl, Bracket and PTT Unit
7.
Install idle exhaust passage.
Idle exhaust passage is designed to reduce engine idling
noise.
After installing the idle exhaust passage, check that no
exhaust gas and cooling water leak through the
installation face.
Idle Exhaust Installation Bolts q :
6 N · m (4 lb · ft) [0.6 kgf · m]
9) Removing Steering Shaft Arm
Remove "C" ring 1 that supports mount bracket.
1.
Remove mount bracket 2.
2.
When mount bracket cannot be removed, tap the
bracket at both ends alternately by using a plastic
hammer.
7-24
1
2
q
TLDI 75/90C2 2010