Table of Contents
Advertisement
3.3.
GENERAL PURPOSE INPUTS AND OUTPUTS
Number:
4 (configurable as inputs or outputs)
Type:
Opto-isolated, active low with internal pull-ups to +5 or +12V (jumper settable)
Connector:
6 pin removable terminal block
Signal Level:
closure to ground
Function:
Inputs:
User Preset select
Outputs:
3.4.
ELECTRICAL
Voltage:
+12VDC
Power:
20 Watts.
EMI/RFI:
Complies with FCC regulations for class A devices.
Complies with EU EMC directive.
3.5.
PHYSICAL
Number of slots:
7700 frame mounting:
7701 frame mounting:
4.
STATUS INDICATORS
The 7710UC-KF has 3 LED Status indicators on the main circuit board front card edge to show operational
status of the card at a glance. Figure 5 shows the location of the LEDs and card edge controls.
Two large LEDS on the front of the board indicate the general health of the module
LOCAL FAULT:
This Red LED indicates poor module health and will be On during the absence of a
valid input signal or if a local input power fault exists (i.e.: a blown fuse). The LOCAL
FAULT indication can also be reported to the frame through the FRAME STATUS
jumper.
MODULE OK:
This Green LED indicates good module health. It will be On when a valid input
signal is present, and the board power are good.
VIDEO PRESENT
This Green LED will be ON when there is a valid fill signal present at the module
input.
GENLOCK
This Green LED will be ON when there is a signal present at the module genlock
input. This LED will blink to indicate that an incorrect signal appropriate for the
current video format is present.
5.
CARD EDGE CONTROLS
The 7710UC-KF is equipped with an 8 position DIP switch to allow the user to select various functions. All
positions are assigned sequentially such that the DIP switch 1 is located at the top of the DIP switch
2
1
Revision 0.2
7700 MultiFrame Manual
7710UC-KF HD Key/Fill Up Converter
7710UC-KF-5
Advertisement
Table of Contents
