1. Remove the power from both power inputs.
!
If power is being supplied to the 3410, a shock hazard exists when you remove
the top cover. Make sure that you have removed power from both power cords
before opening the unit.
2. Remove the top cover screws and carefully place them aside.
3. The Setup Pedestal jumper J45 is located near the center of the board at the front of the unit. To
turn off the pedestal, position on the header so that the shorting jumper is on pins 2 and 3 as shown
in the picture.
4. Replace the top cover and reinstall the screws.
5. Apply power to the unit. When you connect 525 line video to the Multivert, the NTSC output will
have the setup pedestal removed.
2.5.
FRONT PANEL LED STATUS INDICATORS
Figure 6: Setting the NTSC Setup Pedestal Jumper
Figure 7: Front Panel
Model 3410 Multivert Manual
Revision 1.2
Page 6