First Time Set-Up; Figure 2-4: 4015 Or 4025 To Keykode Decoder Cable - evertz 5550 Operating Instructions Manual

2.5.

FIRST TIME SET-UP

INSTALLATION
Model 5550 Universal Film Data Decoder Manual
4015/4025 End
Male DB 9
Description
Shield
Gnd
RxD

Figure 2-4: 4015 or 4025 to KeyKode Decoder Cable

After applying power to the Decoder unit, check to make sure that you are
using the correct sensor for the film type you are using by pressing the
MODE key. The active sensor will be shown in the front panel display.
SENSOR =35mm
SENSOR =35mm REV
SENSOR =16mm
To select a different sensor, press the SHIFT + MODE keys until the
desired sensor is displayed.
normal KeyKode display.
In addition you need to select whether you are reading from negative or
print film stock. This is accomplished using the SETUP menu. To enter
the front panel SETUP menus, press the SETUP key. Press the down
arrow key ($) until you have selected the type menu item. If the film type
is incorrect, press the % key to select other film type. When you have
made the desired change, press the SETUP key to return to the normal
display mode. (See sections 3.2 and 3.3 for more information about the
SETUP menu system).
KeyKode Decoder End
Pin No
----------------------------------
2
3
4
5
6-------------------------------- 5
7
8-------------------------------- 2
9
lower 35mm KeyKode sensor is active
upper 35mm KeyKode sensor is active
(this is used when the film was rewound before
loading it into the camera)
16mm KeyKode sensor is active
Press the DISPLAY key to return to the
Male DB 9
Pin No Description
Shield
Gnd
TxD
Page 2-7