Table of Contents
Advertisement
6.3.
CONFIGURING THE VIDEO CONTROLS
The Video menus are used to configure parameters associated with the input and output video standards
and output video timing. The chart below shows the items available in the Video menu. Sections 6.3.1 to
6.3.6 give detailed information about each of the menu items.
Video Frame Rate
DIP Frame Rate
Video Standard Input
Video Standard Output
DIP Video Out
Reference Select
V Phase Offset
H Phase Offset
6.3.1. Setting the Video Input and Output Frame rate
Video
Frame Rate
59.94/29.97/23.98
50/25
6.3.2. Displays the Video Input and Output Frame rate set by the DIP switches
Video
DIP Frame Rate
59.94/29.97/23.98
50/25
Select the video input frame rate
Displays the video input frame rate set by the DIP switches
Selects the video input standard.
Selects the video output standard.
Displays the video output format set by the DIP switches
Selects internal or video and locking reference
Sets the vertical phase of the output signal to the genlock reference
input
Sets the horizontal phase of the output signal to the genlock reference
input
This control selects the group of frame rates that are available on the Input
Standard menu item.
converting from one frame rate to another is not possible.
Grayed out frame rates are currently unavailable in this release.
This menu item displays the group of frame rates set by DIP switches 6 and
7. Table 2 shows the DIP switch settings to select each of the frame rates.
When DIP switches 6 and 7 are set to the OFF position, the frame rate is
set by the Output Standard Menu item if DIP switch 8 is set to Off or by
VistaLINK™ if DIP switch 8 is set to On.
Revision 0.2
7710UC-KF HD Key/Fill Up Converter
The card does not do temporal processing so
7700 MultiFrame Manual
7710UC-KF-9
Advertisement
Table of Contents
