Connecting The Reader Head To The 4025; Connecting The Keykode Decoder To The Film Footage Encoder; First Time Set-Up - evertz 4025 Instruction Manual

KEYKODE READER INSTALLATION

8.2.2. Connecting the Reader Head to the 4025

A 10 foot long extender cable is supplied to connect the reader head to the model
4025. If you wish to mount the console more than 10 feet from the telecine, 50
foot extended cables may be purchased. The 4025 may be located up to a
maximum distance of 100 feet from the reader head. Plug the extender cable into
the connector on the reader head cable. Connect the other end of the extender
cable to the 8 pin mini DIN HEAD connector on the rear of the 4025.

8.2.3. Connecting the Keykode decoder to the Film Footage Encoder

A 9 pin D connector on the rear of the KeyKode decoder labeled provides RS-232
serial data communications with the 4015 or 4025 Film Footage Encoder. Use the
cable supplied (Part No. WA-C67) or wire a longer cable if required.
information for the WA-C67 cable is as shown in Figure 7-1. Maximum suggested
length of this cable is 50 feet, although longer cables may be used if the wire size
is made larger. Care should be taken to ensure that shielded cable is used, and
that the shield is connected through. The KeyKode reader connects to the Serial
I/O connector on the 4015 and the AUX I/O connector on the 4025.
4015/4025 End
Male DB9
Description
Shield
Gnd
RxD
Figure 8-3: 4015 or 4025 to KeyKode Decoder Cable

8.2.4. First Time Set-Up

After applying power to the 5500, check to make sure that you are using the
correct sensor for the film type you are using by pressing the MODE key. The
active sensor will be shown in the front panel display.
SENSOR =35mm
SENSOR =35mm REV
SENSOR =16mm
To select a different sensor, press the SHIFT + MODE keys until the desired
sensor is displayed. Press the DISPLAY key to return to the normal KeyKode
display.
In addition you need to select whether you are reading from negative or print film
stock. This is accomplished using the SETUP menu. To enter the front panel
SETUP menus, press the SETUP key. Press the down arrow key (!) until you
have selected the type menu item. If the film type is incorrect, press the " key to
select other film type.
Model 4025 Film Footage Encoder Manual
Pin No
2
3
4
5
6
7
8
9
lower 35mm KeyKode sensor is active
upper 35mm KeyKode sensor is active
(this is used when the film was rewound before
loading it into the camera)
16mm KeyKode sensor is active
When you have made the desired change, press the
KeyKode Decoder End
Male DB 9
Pin No Description
Shield
5 Gnd
2 TxD
Page 8-5
Wiring