Setting The Status Poll Polling Rate; Outputting The Module Status At Any Time; Selecting The Fault Log Event Stamp Mode; Enabling The Fault Logging Output - evertz 7700 Manual

7700 MultiFrame Manual
7735AVC-LB Video Composite Encoder and Audio DAC with SoftSwitch

7.8.2.1. Setting the Status Poll Polling Rate

Utilities
Data logging
Status poll setup
Poll rate
1 to 60 min
1 min

7.8.2.2. Outputting The Module Status At Any Time

Utilities
Data logging
Status poll setup
Query status
Yes
No

7.8.2.3. Selecting the Fault Log Event Stamp Mode

Utilities
Data logging
Fault log setup
Event stamp mode
Free run,
VITC

7.8.2.4. Enabling the Fault Logging Output

Utilities
Data logging
Fault log
Disable
Enable

7.8.2.5. Enabling the Status Logging Output

Utilities
Data logging
Status log
Disable
Enable
7735AVC-LB - 34
This control sets the rate at which card status is sent out the rear serial
port.
The status includes all items from the status window, AP and FF EDH
error states, and the audio format error state.
This menu item is used to output the card status regardless of whether
the polling rate timer has expired. Each time the Query status menu
item is set to Yes, the card status is output on the serial port.
When a fault state changes, the AVC will time stamp the fault log output.
This control selects whether the AVC will use VITC (if present) or an
internal free-running clock to time stamp the fault log.
This control selects whether or not fault log data should be sent out the
serial port.
When Fault logging is enabled, a text message is sent out the serial port
when a fault condition changes.
This control selects whether or not status log data should be sent out to
the serial port.
When Status logging is enabled, text messages representing the current
status of the 7735AVC-LB are sent out the serial port at the poll rate
specified in the Status poll rate menu item (see section 7.8.2.1).
Revision 1.6