Table of Contents
Advertisement
3
SPECIFICATIONS
This chapter describes the specifications of the I/O module.
3.1
General Specifications
Item
Operating ambient temperature
Storage ambient temperature
Operating ambient humidity
Storage ambient humidity
Vibration resistance
Shock resistance
Operating atmosphere
*1
Operating altitude
Installation location
*3
Overvoltage category
*4
Pollution degree
Equipment class
*1 Do not use or store the I/O module under pressure higher than the atmospheric pressure of altitude 0m. Doing so may cause
malfunction. When using the I/O module under pressure, please consult your local Mitsubishi representative.
*2 If the environment satisfies the operating ambient temperature, operating ambient humidity and other conditions, the module can be
used even outside the control panel.
*3 This indicates the section of the power supply to which the equipment is assumed to be connected between the public electrical power
distribution network and the machinery within premises.
Category applies to equipment for which electrical power is supplied from fixed facilities. The surge voltage withstand level for up to
the rated voltage of 300V is 2500V.
*4 This index indicates the degree to which conductive material is generated in terms of the environment in which the equipment is used.
Pollution degree 2 is when only non-conductive pollution occurs. A temporary conductivity caused by condensing must be expected
occasionally.
To ensure that this product complies with the EMC Directive, refer to the following.
Page 129 EMC and Low Voltage Directives
3 SPECIFICATIONS
16
3.1 General Specifications
Specifications
0 to 55
-25 to 75
5 to 95%RH, non-condensing
Compliant with JIS
B 3502 and IEC
61131-2
Under intermittent
vibration
Under continuous
vibration
Compliant with JIS B 3502 and IEC 61131-2 (147m/, 3 times each in X, Y, and Z directions)
No corrosive gases, flammable gases, less conductive dust
0 to 2000m
*2
Inside a control panel
or less
2 or less
Class
Frequency
Constant
acceleration
5 to 8.4Hz
8.4 to 150Hz
9.8m/
5 to 8.4Hz
8.4 to 150Hz
4.9m/
Half amplitude
Sweep count
3.5mm
10 times each in X,
Y, and Z directions
1.75mm
Advertisement
Table of Contents
Troubleshooting
