Figure 6.1 Delayed Sweep Mode - Rigol MSO8000A Series User Manual

Digital oscilloscope
Hide thumbs Also See for MSO8000A Series:
Table of Contents

Advertisement

NOTE
To enable the delayed sweep, you must ensure that the current time base mode is "YT".
In delayed sweep mode, the screen is divided into two display areas as shown in
Figure 6.1
Main Time Base
Waveform before enlargement:
The waveform in the area that is not covered by subtransparent blue in the upper part
of the screen is the waveform before enlargement. Its horizontal time base (also
called main time base) is displayed at the upper-left corner of the screen. You can
rotate the Horizontal
Horizontal
NOTE
If you need to modify the horizontal time base (also called main time base) of the normal
sweep, please disable the delayed sweep function first. Rotate the Horizontal
to set the required main time base, and then enable the delayed sweep function.
Waveform after enlargement:
The waveform in the lower part of the screen is the horizontally expanded delayed
sweep waveform. Its horizontal time base (also called the time base of the delayed
sweep) is displayed on the screen. Compared with the main time base, the time based
of the delayed sweep has increased the waveform resolution. At this time, the
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
.

Figure 6.1 Delayed Sweep Mode

POSITION knob to move the area left and right or rotate the
SCALE knob to enlarge or reduce this area.
To Set the Horizontal System
Waveform Before
Enlargement
Waveform After Enlargement
Horizontal Position of
the Delayed Sweep
SCALE knob
63

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mso8074aMso8154aMso8204a

Table of Contents