Operations and Measurements
•
Press More > Label to set the label for math operation results. For details, refer
to the descriptions in "
9.1.10
Intg
Calculates the integral of the selected source. For example, you can use integral to
measure the area under a waveform or the pulse energy.
Press
•
Press Operation continuously to enable or disable the "Intg" operation function.
•
Press SourceA, and rotate the multifunction knob
SourceA. You can also press SourceA continuously or enable the touch screen to
select the channel. The available channels for SourceA are CH1-CH4 and Ref1-
Ref10.
NOTE
The source of Math2 can be CH1-CH4, Ref1-Ref10, or Math1; the source of Math3 can be
CH1-CH4, Ref1-Ref10, Math1, or Math2; the source of Math4 can be CH1-CH4, Ref1-
Ref10, Math1, Math2, or Math3; only the channels that have been enabled currently can
be selected.
•
Press Offset to set the vertical offset of the operation results. For setting
methods, refer to the descriptions in "
directly rotate Wave Vertical
the vertical offset.
•
Press Scale to set the vertical scale of the operation results. For setting methods,
refer to the descriptions in "
rotate Wave Vertical
Scale.
•
Press AutoSetting to adjust the vertical scale and offset of the operation results
to an optimal value based on the current configuration, so as to better observe.
•
Press More > Bias to set the DC offset correction factor for the input signal.
Note that this parameter can only be set by using the numeric keypad.
•
Press More > Invert to enable or disable the inverted display function of the
waveform.
154
Math Operation Label
> Math1 > Operator to "Intg":
Parameter Setting Method
SCALE or enable the touch screen to adjust the vertical
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
".
to select the channel for
Parameter Setting Method
POSITION or enable the touch screen to adjust
". You can also directly
". You can also