23
System Utility Function Setting
In the system function setting menu, you can set the parameters for the remote
interface and the system-related parameters.
23.1
Remote Interface Configuration
MSO8000A series can communicate with the PC via the USB, LAN, or GPIB (requiring
to work with RIGOL's USB-GPIB adaptor) interface. Before using the remote interfaces,
configure the corresponding interface according to the introductions in the following
section.
23.1.1
LAN Configuration
Before using the LAN bus, use a network cable to connect the oscilloscope to your
local area network. The network interface of the oscilloscope is on the rear panel.
Press
figure. You can view the current network settings and configure the network
parameters.
Current IP Config. Type
Network Parameters
Web Control Info.
Network Status
Different prompts will be displayed according to the current network connection
status.
•
Network Config Succeeded!
•
Acquiring IP...
•
IP Conflict!
•
Disconnected!
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
> IO > LAN to open the LAN setting interface, as shown in the following
Network Status
MAC Address
VISA Descriptor
IP Config. Type
Figure 23.1 Network Connection Setting Interface
System Utility Function Setting
359