Table of Contents
Advertisement
Operations and Measurements
-
-
-
-
-
-
172
Press Lock to lock the AUTO function. To unlock the AUTO function, use the
following two methods:
Method 1: Send the remote command :SYSTem:AUTOscale ON to unlock
the AUTO function.
Method 2: Press Lock again, then a password input dialog box is displayed.
Input the password. By default, there is no password, and press OK to
unlock the function.
NOTE
If you lock the Auto function and then exit the auto setting function menu, you can
press
> More > Auto Config to enter the auto setting function menu again
to unlock the Auto function.
Press Peak to Peak to enable or disable the peak-peak priority setting. This
function is intended for the shifted signal. If there is a large deviation, you
can view the signal waveform in priority when you enable the function.
Press CH to select "All" or "Open".
If you select "All", press
channels (CH1-CH4) in sequence. If no signal is found on the channel, then
the channel is disabled; if a signal is found on the channel, adjust the
channel to an optimal scale to display the signal. If you select "Open", press
and the system will only test the enabled channels.
Press Overlay to enable or disable the waveform overlay display function. If
enabled, waveforms of different channels will be displayed in the same
position of the screen; if disabled, waveforms of different channels will be
displayed on the screen from top to bottom in sequence.
Press Coupling to enable or disable the coupling hold function. If enabled,
after you press
, the settings for the channel coupling remain
unchanged; if disabled, then the channel coupling is, by default, set to "DC".
Press Password, and then the password reset dialog box is displayed, as
shown in the figure below. You can reset the password. The initial password
and the system will test the 4 analog
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Advertisement
Table of Contents
