Table of Contents
Advertisement
Operations and Measurements
•
Press More > Label to set the label for math operation results. For details, refer
to the descriptions in "
•
Press More > Color Grade to enable or disable the color grade display of the
operation results. When enabled, different colors are displayed on the screen to
indicate the times of data acquisition or acquisition probability.
•
Press More > Reset ColorGrade to clear the color grade display and display the
color grade again.
9.1.17
Low Pass
Only allows the signals whose frequencies are lower than the current upper limit
frequency to pass.
Press
•
Press Operation continuously to enable or disable the "LowPass" operation
function.
•
Press SourceA, and rotate the multifunction knob
SourceA. You can also press SourceA continuously or enable the touch screen to
select the channel. The available channels for SourceA are CH1-CH4 and Ref1-
Ref10.
NOTE
The source of Math2 can be CH1-CH4, Ref1-Ref10, or Math1; the source of Math3 can be
CH1-CH4, Ref1-Ref10, Math1, or Math2; the source of Math4 can be CH1-CH4, Ref1-
Ref10, Math1, Math2, or Math3; only the channels that have been enabled currently can
be selected.
•
Press Offset to set the vertical offset of the operation results. For setting
methods, refer to the descriptions in "
directly rotate Wave Vertical
the vertical offset.
•
Press Scale to set the vertical scale of the operation results. For setting methods,
refer to the descriptions in "
rotate Wave Vertical
Scale.
162
Math Operation Label
> Math1 > Operator to "LowPass":
Parameter Setting Method
SCALE or enable the touch screen to adjust the vertical
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
".
to select the channel for
Parameter Setting Method
POSITION or enable the touch screen to adjust
". You can also directly
". You can also
Advertisement
Table of Contents
