Table of Contents
Advertisement
Press Polarity continuously to select "Positive" or "Negative", then press Pulse,
rotate the multifunction knob
width. Its range is from 100 ns to 10 ms. By default, it is 1 μs.
•
Set the Error Action
Press Err Action, and rotate the multifunction knob
the oscilloscope will execute once a failed test is detected. Press down the knob
to select it. You can also press Err Action continuously and press down the
multifunction knob
select it.
-
-
-
17.8
To Enable or Disable the Display of the Statistics of
the Test Results
Press Information continuously to enable or disable the display of the statistics of the
test results. You can also enable the touch screen to tap the icon
corner of the statistics window to close it.
The test results statistics include the number of failed frames, the number of
successful frames, and total number of frames, as shown in the figure below.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
to select it. Also, you can enable the touch screen to
Stop: indicates stopping test when a a pass/fail test event is found.
Beeper: indicates that the beeper sounds an alarm when a pass/fail test
event is found (irrelevant with the on/off status of the beeper).
Screenshot: performs the screenshot operation when a pass/fail test event
is found. If an external storage device is detected, the screenshot will be
saved to the external storage device directly. Otherwise, it will be saved to
the local disk.
NOTE
If "Screenshot" is selected, "Stop" action will be executed forcibly. The test will be
stopped automatically. After the Screenshot operation is completed, the test will
continue.
or use the numeric keypad to set the pulse
to set the operation that
Pass/Fail Test
at the right-upper
287
Advertisement
Table of Contents
