Digital Channel
14.5
To Set the Waveform Display Size
Press Size, then use the multifunction knob
size, and then press down the knob to select it. You can also press Size continuously
or enable the touch screen to select it. The available display sizes are Small, Medium,
and Large.
NOTE
"Large" is only available when the number of currently enabled channels is less than or equal
to 8.
14.6
To Set the Label
By default, the instrument takes D0-D15 as the channel label of the 16 digital
channels. You can set a user-defined label for each digital channel to easily
differentiate the digital channels. You can use the preset label or input a label
manually. Press Label to enter the label setting menu.
•
Enable or disable the label display
Press Display continuously to enable or disable the display of the channel label.
If it is enabled, the label will be displayed at the left side of the waveform.
•
Select a specified digital channel
Press Select and rotate the multifunction knob
channel that needs a label. You can also press Select continuously or enable the
touch screen to select the channel. Select any channel from D0-D15.
•
Use preset labels
Press Library to select a preset label. The available preset labels include ACK,
ADO, ADDR, BIT, CAS, CLK, CS, DATA, HALT, INT, LOAD, NMI, OUT, PAS, PIN, RDY,
RST, RX, TX, WR, MISO, and D0-D15.
•
Input a label manually
Press Label to open the label input interface. You can input the label manually.
For details, refer to descriptions in "
14.7
Group Setting
Press On/Off > Group to enter the user-defined group setting menu. You can
randomly grouping or ungrouping any of the 16 digital channels. You can also directly
press More to enter the menu to group or ungroup channels according to your
needs.
226
to select the desired waveform display
to select the desired digital
Channel Label
".
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.