Table of Contents
Advertisement
- Other (Delay and Phase) parameter measurement
Press
the current measurement category. The available channels include CH1-CH4,
Math1-Math4, and D0-D15.
3. Edge Setting
Press
Number, and EdgeB Number. You can rotate the multifunction knob
"Auto", "First", "Last", or "Any Edge" for the EdgeA Event or EdgeB Event. Then
press down the knob to select it. When EdgeA Event or EdgeB Event selects "Any
Edge", you can set the EdgeA Number and EdgeB Number. The range is from 1 to
1,000.
- First: selects the first edge searched across the screen range to measure.
- Last: selects the last edge searched across the screen range to measure.
- Auto: selects the nearest edge to measure according to the principle of
proximity. By default, "Auto" is selected.
- Any Edge: selects any edge searched across the screen range to measure.
NOTE
Only in "Other" measurement category, can you set these parameters. To select "Other"
measurement category, press
to "Other".
4. Indicator
Press Indicatorcontinuously to enable or disable the indicator. You can also press
descriptions in
5. Measurement Settings
Press Settings to enter the sub-menu of measurement.
•
Press Mode to select the measurement mode to "Normal" or "Precision".
-
-
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
> Add > Source A (Source B) to set the two source channels for
> Add > EdgeSet to set the EdgeA Event, EdgeB Event, EdgeA
> Remove > Indicator to enable or disable the indicator. For details, refer to
Measure Mode
Normal: executes measurement of up to 1 Mpts.
Precision: executes measurement of up to 200 Mpts, improving the
resolution of measurement results. In this mode, the refresh rate of the
waveforms may be reduced.
Operations and Measurements
> Add > Category to set the measurement category
.
to select
183
Advertisement
Table of Contents
