To Trigger the Oscilloscope
Sets the trigger parameter (noise rejection) under this trigger type. For details, refer
Noise Rejection
to descriptions in "
".
Trigger LEVEL/Threshold Level:
Rotate the Trigger
LEVEL knob to adjust the trigger level/ threshold level. Please
refer to descriptions in "
Trigger LEVEL/Threshold Level
". The current trigger level/
threshold level is displayed at the upper-right corner of the screen.
8.7.12
Nth Edge Trigger
Triggers on the Nth edge that appears after the specified idle time. For example, in
the waveform shown in the figure below, the instrument should trigger on the second
rising edge after the specified idle time (the time between two neighboring rising
edges), and the idle time should be within the range between P and M (P< Idle
Time<M). Wherein, M is the time between the first rising edge and its previous rising
edge; P is the maximum time between the rising edges that participate in counting.
Edge Type=
Edge Num=2
M
P
P<Idle Time<M
Figure 8.12 Nth Edge Trigger
Trigger Type:
Press Type, and then rotate the multifunction knob
to select "Nth Edge". Press
down the knob to select the trigger type. Then, the current trigger setting information
is displayed at the upper-right corner of the screen, as shown in the figure below. You
can also press Type continuously or enable the touch screen to select it.
Source Selection:
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
108