Table of Contents
Advertisement
- CAN-FD baud
Three methods are available for setting the CAN-FD baud rate:
- Press CAN-FD Baud, then set the user-defined baud rate with the displayed
- Press CAN-FD Baud to select the preset CAN-FD baud rate. The available
- Press CAN-FD Baud, then rotate the multifunction knob
- FD sample position
FD sample position is a dedicated parameter configured for the CAN-FD
decoding.Press FD Sample Position, then rotate the multifunction knob
use the pop-up numeric keypad to set the FD sample position. The settable
range is from 10% to 90%.
5. Set Display-related Parameters
Press Display to enter the display setting menu.
- Set the display format
Press Format, rotate the multifunction knob
the bus data. Then, press down the knob to select it. You can also press Format
continuously or enable the touch screen to select it. The available formats
include Hex, Dec, Bin, and ASCII.
- Adjust the vertical position of the bus
Press Position, and then rotate the multifunction knob
display position of the bus. You can also rotate Wave Vertical
adjust the vertical display position of the bus.
- Set the label display
Press Label to enable or disable the label display of the CAN decoding bus.
When enabled, the bus label "CAN" will be displayed at the upper-left side of
the bus (when the bus display is enabled).
- Set parameters for the event table
Press Event Table to enter the event table setting menu. The event table
displays the decoded data and the corresponding decoding information in time
order in the form of a table. It can be used to observe relatively longer decoded
data. The decoding information includes the decoded data, the corresponding
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
numeric keypad.
baud rates it 1 Mbps, 2 Mbps, 3 Mbps, 4 Mbps, and etc.
CAN-FD baud rate at a small step.
Protocol Decoding
to adjust the
to select the display format of
to adjust the vertical
POSITION to
or
263
Advertisement
Table of Contents
