Table of Contents
Advertisement
-
NOTE
•
Modifying the threshold will affect the measurement results of time, delay and phase
parameters.
•
If you select "Manual" for the amplitude method, the measurement results of other
parameters may be affected.
•
"Histogram" and "Max-Min" are the internal measurement algorithm for the oscilloscope.
The "Histogram" method here is different from the Histogram function of the
oscilloscope.
9.2.4
Remove the Measurement Result
This oscilloscope allows you to remove the measurement results of the parameters.
Press
•
Press Remove to remove the last added measurement item. Note that pressing
this key one time can only remove one measurement item. When you remove a
measurement item, the measurement result of the last added item at the bottom
of the screen will be removed. You can rotate the multifunction knob
switch the measurement item, then press down the knob
remove the item. You can also enable the touch screen to tap the desired
measurement item, and then press Remove to remove the item.
•
Press Remove All to remove all the displayed measurement items.
•
Press Indicator to enable or disable the indicator.
Besides, you can also press
TIP
If the "Remove" sub-menu is not displayed in the current menu, when you select a certain
measurement item, the system will automatically enter the "Remove" sub-menu.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Select "Amp Method", and then press Amp Method to select "Auto" or
"Manual". This method affects the measurement method for the top and
base values. If you select "Manual", you need to set the following
parameters:
--Press Top to select "Histogram" or "Max-Min".
--Press Base to select "Histogram" or "Max-Min".
> Remove to enter the "Remove" sub-menu.
Operations and Measurements
> Add > Remove to enter the "Remove" sub-menu.
to
or press Remove to
185
Advertisement
Table of Contents
