Table of Contents
Advertisement
: Press this key to enter the measurement setting menu. You can set the
measurement source, enable or disable the all measurement function, the statistical
analysis function, and etc. You can make a quick measurement for 41 waveform
parameters.
: Press this key to enter the acquisition setting menu. You can set the time base
mode, the acquisition mode, memory depth, and etc.
: Press this key to enter the file or waveform storage and load interface. The file
types for storage include image, waveform, and setups. Besides, waveform load and
setup load are supported. The disk management and file auto naming function are
also supported in this menu.
: Press this key to enter the cursor measurement menu. The oscilloscope
provides four cursor modes: Manual, Track, XY, and Measure. Note that XY cursor
mode is only available when the horizontal time base is set to "XY".
: Press this key to enter the Display setting menu. You can set the display type,
persistence time, wave intensity, and etc.
: Press this key to enter the system function setting menu. You can set system-
related functions or parameters, such as I/O, sound, language, and etc. Besides, some
advanced functions (such as the pass/fail test, waveform recording, and self-
calibration) are also supported.
4.6.11
Touch Lock Key
NOTE
By default, the touch screen function of the oscilloscope is always enabled. If you disable the
function, press the key again to enable it.
4.6.12
Quick key (shortcut key)
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Press this key to disable the touch screen function.
Press this key to perform the quick operation, including screenshot,
waveform saving, setup saving, all measurement, statistics reset, and etc.
Press
> More > Quick settings to set the quick shortcut keys.
Quick Start
31
Advertisement
Table of Contents
