Table of Contents
Advertisement
To Set the Horizontal System
trigger point moves right on the screen; when rotate it counterclockwise, the
waveform trigger point moves left. Press down this knob to quickly reset the
horizontal position (the horizontal position is reset to zero).
•
Enable the touch screen function, and then adjust the Horizontal Position with
the drag gesture. For details, refer to the "
•
Enable the touch screen function, and tap the Horizontal position label
at the top of the screen. The following window is displayed. Tap the
icon at the right side of the Pos input field to decrease or increase the horizontal
position.You can also tap the Pos input field to input a specific value with the
displayed numeric keypad.
NOTE
When the delayed sweep is enabled, rotate the Horizontal
horizontal position of the delayed sweep (press down the knob to quickly reset it). The
horizontal position of the delayed sweep at the upper-right corner of the screen changes
accordingly.
6.3
Delayed Sweep
Delayed sweep can be used to enlarge a length of waveform horizontally to view
waveform details.
In the horizontal control area on the front panel, press
delayed sweep. By default, it is disabled. You can also press
enable or disable the delayed sweep function.
62
Decrease the position
Increase the position
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Drag
" section.
POSITION to adjust the
to enable or disable the
> More > Zoom to
Advertisement
Table of Contents
