Table of Contents
Advertisement
Protocol Decoding
Press Format, rotate the multifunction knob
the bus data. Then, press down the knob to select it. You can also press Format
continuously or enable the touch screen to select it. The available formats
include Hex, Dec, Bin, and ASCII.
- Adjust the vertical position of the bus
Press Position, and then rotate the multifunction knob
display position of the bus. You can also rotate Wave Vertical
adjust the vertical display position of the bus.
- Set the label display
Press Label to enable or disable the label display of the LIN decoding bus.
When enabled, the bus label "LIN" will be displayed at the upper-left side of the
bus (when the bus display is enabled).
- Set parameters for the event table
Press Event Table to enter the event table setting menu. The event table
displays the decoded data and the corresponding decoding information in time
order in the form of a table. It can be used to observe relatively longer decoded
data. The decoding information includes the decoded data, the corresponding
line number, time, frame ID, cyclic redundancy check (CRC), and error
information.
- Open or close the event table: Press Event Table continuously to enable or
256
disable the display of the event table. When enabled, the following event
Figure 15.9
table as shown in
screen to tap the icon
it.
to select the display format of
is displayed. You can also enable the touch
at the right-upper corner of the event table to close
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
to adjust the vertical
POSITION to
Advertisement
Table of Contents
