Table of Contents
Advertisement
- Set the endian
Press Endian continuously to select "Normal" or "Invert" as the endian of the
bus.
- Set the polarity
Press Polarity continuously to select Positive
for data decoding.
4. Set Display-related Parameters
Press Display to enter the display setting menu.
- Set the display format
Press Format, rotate the multifunction knob
the bus data. Then, press down the knob to select it. You can also press Format
continuously or enable the touch screen to select it. The available formats
include Hex, Dec, Bin, and ASCII.
- Adjust the vertical position of the bus
Press Position, and then rotate the multifunction knob
display position of the bus. You can also rotate Wave Vertical
adjust the vertical display position of the bus.
- Set the label display
Press Label to enable or disable the label display of the Parallel decoding bus.
When enabled, the bus label "Parallel" will be displayed at the upper-left side of
the bus (when the bus display is enabled).
- Set parameters for the event table
Press Event Table to enter the event table setting menu. The event table
displays the decoded data and the corresponding decoding information in time
order in the form of a table. It can be used to observe relatively longer decoded
data. The decoding information includes the decoded data, the corresponding
line number, and time information.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Protocol Decoding
or Negative
as the polarity
to select the display format of
to adjust the vertical
POSITION to
233
Advertisement
Table of Contents
