Table of Contents
Advertisement
9.2
Auto Measurement
This series oscilloscope provides auto measurements for 41 waveform parameters,
enabling users to make statistics and analysis of the measurement results.
9.2.1
Quick Measurement after AUTO
When the oscilloscope is correctly connected and has detected a valid input signal,
press
function menu.
•
automatically on the screen. Meanwhile, the system will make measurements for
the "Period" and "frequency" of the currently displayed waveforms in a of single
period. The measurement results are displayed at the bottom of the screen.
•
automatically on the screen. Meanwhile, the system will make measurements for
the "Period" and "frequency" of the currently displayed waveforms in multiple
periods. The measurement results are displayed at the bottom of the screen.
•
: Press this key, and then one rising edge of the signal is displayed
automatically on the screen. Meanwhile, the system will make measurements for
the "rise time" of the currently displayed rising edge. The measurement results
are displayed at the bottom of the screen. By default, it is intended for the fast
edge signal.
•
automatically on the screen. Meanwhile, the system will make measurements for
the "fall time" of the currently displayed falling edge. The measurement results
are displayed at the bottom of the screen. By default, it is intended for the fast
edge signal.
•
: Press this key, and the system returns to the last set menu.
•
Press Option to enter the auto setting function menu.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
to enable the waveform auto setting function and open the auto setting
: Press this key, and then the single period of the signal is displayed
: Press this key, and then multiple periods of the signal are displayed
: Press this key, and then one falling edge of the signal is displayed
Operations and Measurements
171
Advertisement
Table of Contents
