Table of Contents
Advertisement
Protocol Decoding
Press Label to enable or disable the label display of the I2S decoding bus.
When enabled, the bus label "I2S" will be displayed at the upper-left side of the
bus (when the bus display is enabled).
- Set parameters for the event table
Press Event Table to enter the event table setting menu. The event table
displays the decoded data and the corresponding decoding information in time
order in the form of a table. It can be used to observe relatively longer decoded
data. The decoding information includes the decoded left channel data, right
channel data, the corresponding line number, and time.
- Open or close the event table: Press Event Table continuously to enable or
- Set the event table format: Press Format, rotate the multifunction knob
274
disable the display of the event table. When enabled, the following event
table as shown in
Figure 15.14
screen to tap the icon
it.
Line Number Time
Event Table
I2S Bus
Figure 15.14 I2S Decoding Event Table
NOTE
-
When you adjust the horizontal time base, the waveform displayed on the screen
will also change, and the total number of lines containing the decoding
information in the event table will also be changed.
-
The displayed decoded data information in the bus is related to the value of the
horizontal time base. Reducing the horizontal time base can help you view the
detailed information.
to select the display format of the decoded data. Then, press down the knob
is displayed. You can also enable the touch
at the right-upper corner of the event table to close
Left Channel Data
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Right Channel Data
Advertisement
Table of Contents
