input switch key and press the knob
is located first and highlighted.
2. Clear the Name Input Area
If there is no character in the "Name Input Area", please go to Step 3. If there are
characters in the "Name Input Area", rotate the multifunction knob
Delete key
3. Input the First Character "F"
a. If the current setting is uppercase input, please go to Step 2. If the current
setting is lowercase input, rotate the multifunction knob
press down the knob to switch to the uppercase input.
b. Rotate the multifunction knob
character is displayed in the input area.
4. Input the Other Characters
Use the same method to input the remaining letters "ilename" by referring to Step
3. Pay attention to the upper-lower case of the letters when inputting them.
5. Modify or Delete the Unwanted Characters that Have Been Entered
While entering a value, you can modify or delete the unwanted character if
necessary. To delete the input characters, rotate the multifunction knob
virtual keypad to select the delete key
characters. To modify the characters that have been input, delete the unwanted
characters first and then input the new characters. If the character to be modified
is in the middle, press the delete key to delete the characters starting from the last
one to the character to be modified, then input the new character again.
If the touch screen is enabled, tap to directly move the cursor to the character
required to be modified or deleted, and then input the desired character again or
delete the unwanted character.
TIP
If characters already exist in the letter input area, when you rotate the multifunction knob
to delete the characters in the name input area, the characters in the letter input area
will be deleted first.
6. After finishing the input, rotate the multifunction knob
oscilloscope will create a folder or a specified type of file with this name under the
current path.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
to delete all the characters in the name input area in order.
to select "F" and press down the knob. The
continuously to switch to "En/中/繁". "En"
to select "Caps" and
. Press down the key to delete the
and press OK. The
Store and Load
to select the
in the
335