Table of Contents
Advertisement
Horizontal System
6.3
1.888.610.7664
DHO1000 User Guide
the horizontal position label ("D" icon) changes accordingly, as shown in the figure
below.
You can adjust the horizontal position in the following ways.
•
Rotate the Horizontal
to adjust the horizontal position within the adjustable range. Rotate this knob
clockwise to reduce the horizontal position or counterclockwise to increase the
horizontal position. Pressing the knob can quickly reset the horizontal position
(set the horizontal position to 0).
•
Enable the touch screen function, and then adjust the horizontal position with
the drag gesture. For details, refer to
•
In the "Horizontal" menu, use the corresponding multipurpose knob to set the
horizontal position or use the icons at the right side of the input field of Position
to increase or decrease the value, as shown in the figure below. You can also click
or tap the Position input field to input a specific value with the pop-up numeric
keypad.
Zoom Mode (Delayed Sweep)
Zoom (delayed sweep mode) can be used to horizontally expand a length of
waveform to view waveform details. In the Horizontal menu, click or tap the Zoom
on/off switch to enable or disable the delayed sweep function. When it is enabled,
you can set the scale and position in Zoom mode.
•
Zoomed Scale: Rotate the corresponding multipurpose knob or use the icons at
the right of the Scale input field to increase or decrease the time base for the
www.calcert.com
15
10
20
5
25
0
30
POSITION knob at the right section of the front panel
Drag
.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
sales@calcert.com
Advertisement
Table of Contents
