Zoom Mode (Delayed Sweep) - Rigol HDO1000 Series User Manual

Horizontal System
the horizontal position label ("D" icon) changes accordingly, as shown in the figure
below.
You can adjust the horizontal position with the following methods.
• Rotate the Horizontal
to adjust the horizontal position within the adjustable range. Rotate this knob
clockwise to reduce the horizontal position or counterclockwise to increase the
horizontal position. Pressing the knob can quickly reset the horizontal position
(set the horizontal position to 0).
• Enable the touch screen function, and then adjust the horizontal position with
the drag gesture. For details, refer to
• In the "Horizontal" menu, use the corresponding multipurpose knob to set the
horizontal position or use the icons at the right side of the input field of Position
to increase or decrease the value, as shown in the figure below. You can also click
or tap the Position input field to input a specific value with the pop-up numeric
keypad.
6.3

Zoom Mode (Delayed Sweep)

Zoom (delayed sweep mode) can be used to horizontally expand a length of
waveform to view waveform details. In the Horizontal menu, click or tap the Zoom
on/off switch to enable or disable the delayed sweep function. When it is enabled,
you can set the scale and offset for the delayed sweep.
• Scale: Rotate the corresponding multipurpose knob or use the icons at the right
of the Scale input field to increase or decrease the time base for the Zoom
HDO1000 User Guide
52
POSITION knob at the right section of the front panel
Drag
.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.