Operations and Measurements
•
Press Operation continuously to enable or disable the "AX+B" operation
function.
•
Press SourceA, and rotate the multifunction knob
SourceA. You can also press SourceA continuously or enable the touch screen to
select the channel. The available channels for SourceA are CH1-CH4 and Ref1-
Ref10.
NOTE
The source of Math2 can be CH1-CH4, Ref1-Ref10, or Math1; the source of Math3 can be
CH1-CH4, Ref1-Ref10, Math1, or Math2; the source of Math4 can be CH1-CH4, Ref1-
Ref10, Math1, Math2, or Math3; only the channels that have been enabled currently can
be selected.
•
Press Offset to set the vertical offset of the operation results. For setting
methods, refer to the descriptions in "
directly rotate Wave Vertical
the vertical offset.
•
Press Scale to set the vertical scale of the operation results. For setting methods,
refer to the descriptions in "
rotate Wave Vertical
Scale.
•
Press AutoSetting to adjust the vertical scale and offset of the operation results
to an optimal value based on the current configuration, so as to better observe.
•
Press More > A to set the value of A. Note that this parameter can only be set
by using the numeric keypad.
•
Press More > B to set the value of B. Note that this parameter can only be set by
using the numeric keypad.
•
Press More > Invert to enable or disable the inverted display function of the
waveform.
•
Press More > Label to set the label for math operation results. For details, refer
to the descriptions in "
168
Parameter Setting Method
POSITION or enable the touch screen to adjust
Parameter Setting Method
SCALE or enable the touch screen to adjust the vertical
Math Operation Label
".
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
to select the channel for
". You can also
". You can also directly