Table of Contents
Advertisement
Rotate the Trigger
refer to descriptions in "
threshold level is displayed at the upper-right corner of the screen.
8.7.8
Runt Trigger
This trigger mode is used to trigger pulses that pass through one trigger level but fail
to pass through another trigger level, as shown in the figure below.
Upper Limit of the
Trigger Level
Lower Limit of the
Trigger Level
Trigger Type:
Press Type, and then rotate the multifunction knob
the knob to select it. Then, the current trigger setting information is displayed at the
upper-right corner of the screen, as shown in the figure below. You can also press
Type continuously or enable the touch screen to select it.
Source Selection:
Press Source to switch the trigger source and select CH1-CH4. For details, refer to
descriptions in "
right corner of the screen.
NOTE
Only when we select the channel (that has been input with signals) as the trigger source, can
we obtain a stable trigger Wave.
Polarity:
Press Polarity to select the polarity of the Runt trigger.
•
Positive: triggers on the positive runt pulse.
•
Negative: triggers on the negative runt pulse.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
LEVEL knob to adjust the trigger level or threshold level. Please
Trigger LEVEL/Threshold Level
Positive Runt Pulse
Figure 8.9 Runt Trigger
Trigger Source
". The current trigger source is displayed at the upper-
To Trigger the Oscilloscope
". The current trigger level/
Negative Runt Pulse
to select "Runt". Press down
99
Advertisement
Table of Contents
