Table of Contents
Advertisement
Operations and Measurements
rotate Wave Vertical
Scale.
•
Press More > AutoSetting to adjust the vertical scale and offset of the
operation results to the optimal value according to the current configuration for
better observation.
•
Press More > Invert to enable or disable the inverted display function of the
waveform.
•
Press More > Expand to expand or compress the math operation waveform
around the "Center" or "GND".
•
Press More > Label to set the label for math operation results. For details, refer
to descriptions in "
•
Press More > Color Grade to enable or disable the color grade display of the
operation results. When enabled, different colors are displayed on the screen to
indicate the times of data acquisition or acquisition probability.
•
Press More > Reset ColorGrade to clear the color grade display and display the
color grade again.
9.1.3
Multiplication
Multiply the waveform voltage values of signal source A and B point by point and
display the results.
Press
•
Press Operation continuously to enable or disable the multiplication operation
function.
•
Press SourceA and SourceB respectively, and rotate the multifunction knob
to select the channel for SourceA and SourceB. Then press down the knob to
select the channel. You can also press SourceA and SourceB continuously or
enable the touch screen to select the channel. The available channels for
SourceA and SourceB are CH1-CH4 and Ref1-Ref10.
NOTE
The source of Math2 can be CH1-CH4, Ref1-Ref10, or Math1; the source of Math3 can be
CH1-CH4, Ref1-Ref10, Math1, or Math2; the source of Math4 can be CH1-CH4, Ref1-
140
SCALE or enable the touch screen to adjust the vertical
Math Operation Label
> Math1 > Operator to select "A×B":
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
".
Advertisement
Table of Contents
