Table of Contents
Advertisement
18
Waveform Recording and Playing
Waveform recording/playing function can play the recorded waveforms of the analog
input channels (CH1-CH4) and the digital channels (D0-D15), enabling you to analyze
the waveforms better.
NOTE
The horizontal time base must be set to YT mode during waveform recording.
18.1
Common Settings
Press
enable the touch screen and then tap the function navigation icon
left corner of the screen to open the function navigation. Then, tap the "Record" icon
to open the waveform recording setting menu.
1. Record
Press Record continuously to enable or disable the waveform recording function.
Before recording the waveform, you can refer to descriptions in "
to set the waveform recording parameters. Press Record to start recording the
waveforms. Then the record icon turns
current real-time recording information is displayed on the screen, as shown in
Figure 18.1
Its value changes constantly (the value under the Current menu is changing
constantly too). The data at the right of the slash indicate the number of frames for
recording. The time difference ΔT at the upper-right corner indicates the time
different between the current frame and the first frame. After the recording is
completed, the recording marker "
automatically. During recording, you can also press Record again to suspend
recording manually.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
> Record to enter the waveform recording setting menu. You can also
. In the figure, the data at the left side of the slash is the current frame.
Waveform Recording and Playing
from
. During the recording, the
" turns out to be "
" and recording stops
at the lower-
Record Options
"
289
Advertisement
Table of Contents
