Table of Contents
Advertisement
To Trigger the Oscilloscope
Source Selection:
Press Source to open the signal source list and select CH1-CH4 or D0-D15. For
details, refer to descriptions in "
displayed at the upper-right corner of the screen.
NOTE
Only when we select the channel (that has been input with signals) as the trigger source, can
we obtain a stable trigger Wave.
Edge Type:
Press Slope, then rotate the multifunction knob
which the oscilloscope triggers. You can also press Slope continuously or enable the
touch screen to select it.
•
Rising: starts timing when the rising edge of the input signal passes through
the trigger level.
•
Falling: starts timing when the falling edge of the input signal passes through
the trigger level.
•
Either: starts timing when either edge of the input signal passes through the
trigger level.
Timeout Value:
Timeout value represents the maximum time that the signal remains idle before the
signal passes through the trigger level. Press Timeout, and then rotate the
multifunction knob
The available range is from 16 ns to 10 s.
Trigger Mode:
In the trigger control area (Trigger) on the front panel, press
the current trigger mode. For details, refer to descriptions in "
Trigger Parameter Setting:
Sets the trigger parameter (noise rejection) under this trigger type. For details, refer
to descriptions in "
Trigger LEVEL/Threshold Level:
98
Trigger Source
or use the pop-up numeric keypad to set the timeout value.
Noise Rejection
".
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
". The current trigger source is
to select input signal edge on
to quickly switch
Trigger Mode
".
Advertisement
Table of Contents
