•
Press Start, and then the oscilloscope will start to execute the self-calibration
program.
•
After starting the self-calibration program, the Exit menu is no longer grayed
out and is enabled. Press Exit to cancel self-calibration operation at any time.
•
Press Window continuously to open or close the self-calibration information
window. You can also enable the touch screen to tap the icon
upper corner of the self-calibration information window to close it.
NOTE
During the self-calibration process, most of the keys are disabled.
23.2.10
Auto Config
You can set the parameters for the
Press
detailed settings, refer to descriptions in "
23.2.11
Print Setting
Connect the oscilloscope to the local area network via the network cable. This series
supports printing the whole screen to the network printer. You can connect the
oscilloscope to the printer directly via the [USB DEVICE] interface on the rear panel.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Figure 23.2 SelfCal
> More > Auto Config, and set the parameters for the
System Utility Function Setting
menu.
Quick Measurement after AUTO
at the right-
key. For
".
367