Zoom Mode (Delayed Sweep) - Rigol DHO900 User Manual

You can adjust the horizontal position in the following ways.
• Rotate the Horizontal
to adjust the horizontal position within the adjustable range. Rotate this knob
clockwise to reduce the horizontal position or counterclockwise to increase the
horizontal position. Pressing the knob can quickly reset the horizontal position
(set the horizontal position to 0).
•
Enable the touch screen function, and then adjust the horizontal position with
the drag gesture. For details, refer to
•
In the "Horizontal" menu, use the corresponding multipurpose knob to set the
horizontal position or use the icons at the right side of the input field of Position
to increase or decrease the value, as shown in the figure below. You can also click
or tap the Position input field to input a specific value with the pop-up numeric
keypad.
6.3

Zoom Mode (Delayed Sweep)

Zoom (delayed sweep mode) can be used to horizontally expand a length of
waveform to view waveform details. In the Horizontal menu, click or tap the Zoom
on/off switch to enable or disable the delayed sweep function. When it is enabled,
you can set the scale and position in Zoom mode.
Zoomed Time Base
• Zoomed Scale: Rotate the corresponding multipurpose knob or use the icons at
the right side of the Scale input field to increase or decrease the time base for
the Zoom window. You can also click or tap the input field to input the specific
value directly via the pop-up numeric keypad.
• Zoomed Position: Rotate the corresponding multipurpose knob or use the icons
at the right side of the Position input field to increase or decrease the position
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
POSITION knob at the right section of the front panel
Input Field
Input Field for
Increase Decrease
Drag
.
Increase Decrease
Input Field for
Increase Decrease
Zoomed Position
Horizontal System
DHO800 User Guide
49