Table of Contents
Advertisement
Quick Start
After the oscilloscope is connected to network (if you do not have the access to the
Internet, please ask the administrator to open the specified network authority), you can
perform online upgrading for the system software:
1. Enable the touch screen and then tap the function navigation icon
corner of the touch screen to enable the function navigation.
2. Tap the "Help" icon, and then the "Help" menu is displayed on the screen.
3. Press Online upgrade or enable the touch screen to tap "Online upgrade", then a
"System Update Information" window is displayed, requesting you whether to accept or
cancel "RIGOL TERMS OF ONLINE UPGRADE SERVICE". Tap "Accept" to start online
upgrade. Tap "Cancel" to cancel the online upgrade.
3. USB DEVICE Interface
You can connect the instrument to the PC via this interface. Then you can use the
PC software Ultra Scope to send the SCPI commands or use the user-defined
programming to control the instrument.
4. USB HOST Interface
You can connect the storage device that is compatible with the USB to the
instrument via the USB HOST interface.
Connecting the storage device can save or recall the waveform files and setup files,
as well as save the data and screen image. When update is available, you can
perform local upgrading for the system software of the instrument via the USB
HOST interface.
NOTE
Perform local upgrading for the system software:
1. Insert the USB storage device (stored with upgrading files under its root directory) into
the USB HOST interface, and then the "Help" menu is automatically displayed.
2. Press Local upgrade or enable the touch screen to tap "Local upgrade", then a dialog
box "Upgrade system firmware?" is displayed.
3. Press OK or enable the touch screen to tap "OK" to start local upgrade for the
oscilloscope. If you tap "Cancel", the local upgrade will be cancelled.
5. HDMI Video Output
Through this interface, you can connect the instrument to an external display (e.g.
monitor or projector) equipped with the HDMI interface to better observe the
waveform display clearly. At this time, you can also view the waveforms on the LCD
of the instrument.
6. 10 M In/Out
Indicates the reference clock. It can provide accurate sample clock signal for the
oscilloscope, and can be used to synchronize the clock of two or multiple
oscilloscopes.
24
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
at the lower-left
Advertisement
Table of Contents
