Table of Contents
Advertisement
- Open or close the event table: Press Event Table continuously to enable or
- Set the event table format: Press Format, rotate the multifunction knob
- Set the view type: Press View, rotate the multifunction knob
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
disable the display of the event table. When enabled, the following event
table as shown in
Figure 15.13
screen to tap the icon
it.
Line Number Time
Event Table
FlexRay Bus
Figure 15.13 FlexRay Decoding Event Table
NOTE
-
When you adjust the horizontal time base, the waveform displayed on the screen
will also change, and the total number of lines containing the decoding
information in the event table will also be changed.
-
The displayed decoded data information in the bus is related to the value of the
horizontal time base. Reducing the horizontal time base can help you view the
detailed information.
to select the display format of "Data" in the event table. Then, press down
the knob to select it. You can also press Format continuously or enable the
touch screen to select it. The available formats include Hex, Dec, Bin, and
ASC.
form of the event table to be viewed. Then, press down the knob to select it.
You can also press View continuously or enable the touch screen to select it.
The available choices include "Packets", "Details", and "Payload". You can
is displayed. You can also enable the touch
at the right-upper corner of the event table to close
Frame ID PL
Header CRC
Protocol Decoding
Decoded Data
Cycle
Frame CRC
to select the
269
Advertisement
Table of Contents
