Table of Contents
Advertisement
12
Histogram Analysis
This series oscilloscope supports the standard histogram analysis function, enabling
you to judge the trend of waveforms, and quickly locate the potential problems of the
signal.
12.1
To Enable or Disable the Histogram Function
The histogram analysis function supported by this series is available to provide a
statistical view of waveforms or measurement results. It can be classified into
horizontal histogram, vertical histogram, and measurement histogram. With the on-
going acquisition and measurement of the waveforms, the height of the bar graph
will change within the set range of the histogram window to indicate the number of
times for data statistics.
You can go to the "Histogram" setting menu through the following four ways:
•
On the front panel, press
setting menu.
•
Enable the touch screen and then tap the function navigation icon
lower-left corner of the touch screen to enable the function navigation. Then tap
the "Histogram" icon, and the histogram setting menu is displayed at the right
section of the screen.
•
Enable the touch screen and tap the auto measurement label "MEASURE" at the
top of the screen to enter the measurement setting menu. In the measurement
category area, rotate the multifunction knob
and then press down the knob to select it. You can also tap the "Analyze" option
to select it. In the measurement parameter area, rotate the multifunction knob
to select the "Histogram" option and then press down the knob to select it.
You can also tap the "Histogram" option to select it and then enter the
"Histogram" setting menu.
•
Refer to descriptions in "
menu.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
> Analyze > Histogram to enter the histogram
Rectangle Drawing
" to enter the "Histogram" setting
Histogram Analysis
at the
to select the "Analyze" option
209
Advertisement
Table of Contents
