To Create A Mask - Rigol MSO8000A Series User Manual

select the desired source channel, and then press down the knob it. You can also
press Source continuously or enable the touch screen Select to select it. The available
output channels include CH1-CH4.
NOTE
Only the channels that have been enabled currently can be selected.
17.4

To Create a Mask

Press Mask > Create to self-define the mask of the pass/fail test. Press Range, then
rotate the multifunction knob
to select the range. You can also press Range continuously or enable the touch screen
to select it. You can select "Screen" or "Cursor" as the mask region. The default is
"Screen".
• If "Screen" is selected under Range, then the whole waveform display area is
considered to be the mask region. Press X Mask and Y Mask respectively, then
rotate the multifunction knob
the horizontal tolerance range and vertical tolerance range. During the
adjustment, you can see the outline of the current mask. Then press Create to
apply the currently created mask (the region not covered by blue within the
screen).
• If "Cursor" is selected, two cursors (used to specify the current test mask range)
will be displayed on the screen. Cursor A is at the left and Cursor B is at the right.
Press CursorA and CursorB, and rotate the multifunction knob
positions of both Cursor A and Cursor B, respectively. Also you can press
CursorAB and rotate the multifunction knob
synchronously (the horizontal spacing between Cursor A and Cursor B remains
unchanged). Then refer to the above methods to adjust the horizontal and
vertical tolerance ranges, as well as create a mask (the region not covered by
blue within the cursor region).
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
to select the range and then press down the knob
or use with the pop-up numeric keypad to set
to adjust the two cursors
Pass/Fail Test
to adjust the
285