Dräger Zeus Infinity Empowered Instructions For Use Manual page 304

Fault – Cause – Remedy
Classifi- Pri- Alarm text
cation ority
Note 150 Replace SpO
sor
Note 020 RL electrode fail
Warning 200 Rotary knob stuck
Note 050 RV check zero
Caution 090 RV D high
Caution 090 RV D low
Note 025 RV hardware fail
Caution 090 RV M high
Caution 100 RV M low
304
Cause
sen- The SpO sensor is defec-
2 2
tive or of wrong type.
Lead-off condition for indi-
cated lead detected: -Broken
cable - Loose lead wire
- Faulty lead wire - Wrong
lead -Dried out gel -Bad con-
tact.
Rotary knob is stuck or was
pressed for more than
10 seconds.
Pressure transducer for
specified parameter requires
zeroing. The blood pressure
zero of monitor may not cor-
respond to the peripheral de-
vice.
Invasive pressure value out-
side alarm limits.
Invasive pressure value out-
side alarm limits.
Invasive blood pressure
hardware failure.
Invasive pressure value out-
side alarm limits.
Invasive pressure value out-
side alarm limits.
Instructions for use Zeus Infinity Empowered SW 2.n
Remedy
Replace SpO sensor.
2
Check defective cables and
electrodes. Reapply gel to
electrodes. Make sure the
skin is properly prepped.
Select another ECG/ST
lead. Set correct type of ca-
ble.
Press and turn rotary knob
repeatedly. If alarm condi-
tion persists, settings can-
not be adjusted anymore.
Zero the transducer.
Check patient and take ap-
propriate action. Change
the alarm limits if required.
Check equipment and re-
place if necessary.
Check patient and take ap-
propriate action. Change
the alarm limits if required.
Check equipment and re-
place if necessary.
Check hardware and re-
place. Call DrägerService.
Check patient and take ap-
propriate action. Change
the alarm limits if required.
Check equipment and re-
place if necessary.
Check patient and take ap-
propriate action. Change
the alarm limits if required.
Check equipment and re-
place if necessary.