Advertisement
Quick Links
Dräger Zeus® Breathing System
Disassembly/Assembly
Disassembly
Unscrew the CLIC adapter
(optional).
Screw the CLIC adapter
(optional).
Loosen and pull out
the inspiration port.
Check the inspiration grills.
Insert and tighten the
inspiration port.
Lift off the upper part of
the breathing system.
Set the upper part on the lower
part of the breathing system.
* In case the grill is damaged contact DrägerService®
Insert cleaning disc into
the adapter. Close adapter
until it snaps.
Remove cleaning disc from
8
the adapter. Close adapter
until it snaps.
Remove the flow sensors.
5
Insert the flow sensors
Screw off the APL valve.
2
Screw in the APL valve.
Assembly
Loosen and pull out
the expiration port.
Check the expiration grills.*
7
Insert and tighten the
expiration port.
Turn the screws using the key
counterclockwise about 120°.
Turn the screws using the key
4
clockwise about 120°.
6
3
Advertisement
Related Manuals for Dräger Zeus
Summary of Contents for Dräger Zeus
- Page 1 Dräger Zeus® Breathing System Disassembly/Assembly Disassembly Insert cleaning disc into Unscrew the CLIC adapter Loosen and pull out the adapter. Close adapter (optional). the expiration port. until it snaps. Remove cleaning disc from Check the expiration grills.* Screw the CLIC adapter the adapter.
- Page 2 Dräger Zeus® Breathing System Reprocessing Instructions Manual cleaning Machine cleaning Sterilization and disinfection and disinfection Position components so that all interior spaces and surfaces are completely flushed and water can drain off freely. Visual check Manual cleaning and disinfection: Please use the disinfectants listed in the Instructions for use of the Dräger flow sensors.